• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Repair and preparation of the original snap fastener area.
Table 3-4. Snap Fastener Component Chuck and Die Compatibility List

TM-10-1670-201-23 General Maintenance of Parachutes and Other Airdrop Equipment Manual
Page Navigation
  90    91    92    93    94  95  96    97    98    99    100  
TM 10-1670-201-23
T.O. 13C-1-41
NAVAIR 13-1-17
Table 3-3. Hand Tools for Snap Fastener- and Grommet Installation
Tool Nomenclature
Federal Stock Number
Press, Hand, Chuck and Die, 3-Inch, M-369
5120-880-0619
Press, Hand, Chuck and Die, 1 1/2-Inch, M-483
5120-244-9198
Rawhide Mallet, 1 1/4- by 2 3/4-lnch
5120-293-3398
Cutter, Single Bow, 3/16-Inch
5110-180-0941
Cutter, Single Bow, 1/4-Inch
5110-180-0943
Cutter, Single Bow. 5/16-Inch
5110-180-0945
Cutter, Double Bow, 3/8-Inch
5110-541-7697
Cutter, Double Bow, 7/16-Inch
5110-180-0922
Cutter, Double Bow, 1/2-nch
5110-180-0923
Cutter, Double Bow, 9/16-inch
5110-277-9805
Cutter, Double Bow, 5/8-Inch
5110-180-0924
Cutter, Lift-The-Dot Large, 9951
5110-509-8076
Holder, Die Fastener, 192
5120-357-6177
Anvil, Check Fastener, 9002
5120-357-6181
Key, Socket Head Set (Allen Type)
5120-684-7055
Lead, Pig. 5-Pounds (For Cutter Block)
9650-264-5050
(b) Installing a durable or pull-the-dot
snap fastener assembly.
1. Hand-held method.
(a) Using the specifics in table 3-4,
ascertain the size die and chuck required for installing
the fastener cap and socket or stud and post, as
applicable.
(b) Place the selected chuck in the
open end of the holder and secure the chuck in place
using the locking screw located on one side of the
holder. Further place the appropriate die into the anvil.
NOTE
In most instances a chuck will be
installed in the hand-held holder and
a die will be placed in the anvil.
However,  there  may  be  some
occasions that require the location of
the chuck and die to be reversed.
This situation may also apply to the
hand- or foot-operated press.
(c) Fit the socket or stud, as applicable,
on the chuck lower end (fig. 3-37). Place the cap or
post. as applicable, on the die with the barrel facing tip.
Figure 3-38. Snap fastener installation tools,
typical.
3-56






Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.