TM 10-1670-268-20&P 0015 00
UNIT MAINTENANCE
TYPE V AND DUAL ROW AIRDROP PLATFORM
MAIN PANEL ASSEMBLY (TYPE V)/PANEL ASSEMBLY (DUAL ROW)
0015 00-1
THIS WORK PACKAGE COVERS:
Remove
Clean
Inspect
Install
INITIAL SETUP:
Tools:
Brush, Wire (Item 2, WP 0020 00)
File, Mill (Item 7/8, WP 0020 00)
Punch, Aligning (Item 15, WP 0020 00)
Socket, 3/4–IN. (Item 17, WP 0020 00)
Socket, 5/8–IN. (Item 18, WP 0020 00)
Socket, 9/16–IN. (Item 19, WP 0020 00)
Wrench, Box and Open, ¾-IN. (Item 23, WP 0020 00)
Wrench, Box and Open, 5/8–IN. (Item 27, WP 0020 00)
Wrench, Box and Open, 9/16–IN. (Item 28, WP 0020 00)
Wrench, Impact, ½-IN. Drive (Item 30, WP 0020 00)
Materials/Parts:
Brush, Scrub (Item 1, WP 0036 00)
Dishwashing Compound (Item 3, WP 0036 00)
Rag, Wiping (Item 5, WP 0036 00)
Replacement parts from stock, as required.
Applicable Configurations:
All
Personnel Required:
Two – Three 92R (10) Parachute
Rigger
General Safety Instructions:
Observe all warnings and
cautions.
REMOVE
Remove panel assembly as follows:
(Refer to illustration on following page.)
1. Position the platform upside down and remove outrigger assembly (if applicable), side rails and
rollers pads IAW in WP 0012 00 and WP 0013 00.
2. Begin with the panel assembly at rear of platform and remove as many panels as necessary to
replace the defective panel.
3. Remove panel assembly by slightly raising the panel to make disengaging easier.
