TM 10-1670-268-20&P 0016 00
c. Pass a 3/8-inch diameter by 4-inch bolt through 2-inch diameter by ¼-inch thick jumbo washer.
d. Perform alignment check by passing bolt through weldment bolt-hole and corresponding platform
panel bolt-hole from top to botom.
e. Reposition weldment if necessary. Install bolt and washer from the underside of the platform.
Thread a 3/8-inch nut onto bolt by hand. Repeat for remaining bolt-holes on assembly.
Using a ¾-inch wrench or socket, tighten the weldment to the link.
SECURED TO LINK