• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
TYPE V AND DUAL ROW AIRDROP PLATFORM ASSEMBLING THE TYPE V AND DUAL ROW AIRDROP PLATFORM
TYPE V AND DUAL ROW AIRDROP PLATFORM ASSEMBLING THE TYPE V AND DUAL ROW AIRDROP PLATFORM CONT. - TM-10-1670-268-20P_47

TM-10-1670-268-20P The Type V Airdrop Platform and Dual Airdrop Platform Manual
Page Navigation
  26    27    28    29    30  31  32    33    34    35    36  
                                                                   TM 10-1670-268-20&P                                            0004 00 0004 00-2 CAUTION The platform weighs approximately 100-pounds per foot of length.   To avoid injury to personnel or damage to surrounding equipment, use extreme caution when lifting and handling.  Never walk near or crawl beneath the assembled raised platform.  Be careful not to damage the side rail notches when turning-the platform over.  Short pieces of plywood should be used to prevent the edges of the rail from contacting a concrete floor or other hard surface. NOTE Do not hammer screws or bolts through holes of roller pads or side rails due to probable damage to internal fixed components ex., nut bars and encapsulated nuts. c.    The steps required for the assembly of the major components of the type V airdrop platform are as follows: (1) Construct a flat structure of sufficient mass and strength to support the weight of the platform at a safe, convenient work height.  Ensure that the surface design allows for the clearance of the tie down rings.  Ensure the structure is long enough and wide enough to accommodate the size of the platform being constructed.  This allows each panel surface to lay flat and helps to keep the assembled platform flat. NOTE The type V airdrop platform must be assembled upside down.   Roller pad bolts are installed through the roller pad and side rails into the bottom of the main and rear panels.  Riveted-nut plate bars are located inside the panels. Approximately 24-Inch Working Height







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.