TM 10-1670-268-20&P 0004 00
(14) Install a tandem link assembly at each end of the side rail by sliding them within the side
rail aligning the bolt holes on the tandem link with the last three holes at the end of each
the side rail. Install ½-inch X 3 7/32-inch side rail bolts (2) with ½-inch flat washers (3).
Bolts should be left finger tight.
Ensure all side rail bolts, washers, and bushings are installed.
(15) Draw the side rail into proper alignment by fully tightening the forth bolt from each end of
both side rails, using a ¾-inch socket or wrench. All other side rail bolts may then be
tightened, working from the center toward each end of the platform. Refer to the figure
below for details.
PANEL IN SERIES