• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Grommet - TM-10-1670-269-23P_188
UNIT MAINTENANCE 24-FOOT DIAMETER TROOP CHEST RESERVE (T-10R) PARACHUTE AND THE MIRPS PACK TRAY ASSEMBLY FOR THE T-10R AND THE MIRPS CONT. - TM-10-1670-269-23P_190

TM-10-1670-269-23P Parachute Personnel Type: 24-Foot Diameter Troop Chest Reserve (T-10R) NSN 1670-00-892-4218 Manual
Page Navigation
  153    154    155    156    157  158  159    160    161    162    163  
TM 10-1670-269-23&P    0028 00 0028 00-13 (4) Position grommet on die with barrel facing up, position material over grommet barrel, and place the washer over grommet barrel. NOTE When installing a flat grommet by the hand-held method, ensure the grommet barrel and washer are aligned to preclude off-center setting of the grommet. (5) Using a punch and rawhide mallet or other non-steel impact device, spread grommet barrel by hammering until barrel collar is rolled down smooth on washer.  If grommet barrel splits during hammering process, remove and replace damaged grommet with a serviceable item from stock, repeating procedures in paragraph b., above. (6) Check seating of grommet.  If grommet can be turned by hand, repeat step (5) until grommet is firmly seated. (7) Install appropriate chuck or die in hand-operated press and secure locking screws with hex wrench, or screwdriver.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.