24-FOOT DIAMETER TROOP CHEST RESERVE (T-10R) PARACHUTE AND THE MIRPS
THIS SECTION COVERS:
Inspection Kit, Ripcord Grip (Item 12, WP 0044 00)
Tape, Pressure-Sensitive, Blue, ½-IN Wide (Item 32, WP 0057 00)
Tape, Pressure-Sensitive, Yellow, ½-IN Wide (Item 31, WP 0057 00)
92R (10) Parachute Rigger
Replace with a new like item from stock.
1. Perform a ripcord locking pin test on the T-10R and MIRPS ripcord grip as follows:
a. Insert ½-inch of each locking pin end into hole of a fixed ripcord locking pin test. Ensure the block
is firmly secured in the fixed position.
b. Suspend a 7-pound weight from the ripcord grip handle, exercising care to apply the load
gradually without impact. The hands or lifting device, as applicable, must be fully removed from
FIXED TEST BLOCK
T-10R RIPCORD GRIP
MIRPS RIPCORD GRIP