• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
UNIT MAINTENANCE MC1-1B/MC1-1E TROOP BACK PARACHUTE ASSEMBLY   BRIDLE LOOP CONT.
UNIT MAINTENANCE MC1-1B/MC1-1E TROOP BACK PARACHUTE ASSEMBLY   VENT CAP

TM-10-1670-272-23P Parachute Personnel Type: 35-Foot Diameter MC1-1B Troop Back Parachute Assembly NSN 1670-00-598-0751 Manual
Page Navigation
  121    122    123    124    125  126  127    128    129    130    131  
TM 10-1670-272-23&P                                                        0016 00 UNIT MAINTENANCE MC1-1B/MC1-1E TROOP BACK PARACHUTE ASSEMBLY   ORIFICE EDGE REINFORCEMENT 0016 00-1/(2 Blank) THIS TASK COVERS:    Repair INITIAL SETUP: Tools Knife, Hot Metal (Item 14, WP 0043 00) Sewing Machine, Light Duty (Table 1, WP 0012 00)   Shears (Item 28, WP 0043 00) Materials/Parts Tape, Nylon, Type III, ¾-IN. (Item 47, WP 0056 00) Personnel Required 92R (10), Parachute Rigger Equipment Condition Unpacked.  Canopy in proper layout. References Group No. 01, MAC (WP 0046 00) NOTE Both upper and lower portions of the orifice edge reinforcement may be spliced once per gore. REPAIR Splice damaged orifice edge reinforcement as follows: 1. Place canopy on repair table with damaged area up, and smooth out area around damaged orifice edge reinforcement. 2. If only the orifice edge reinforcement is damaged, cut a length of type III nylon tape long enough to extend 4-inches beyond each side of damaged area, and sear ends of tape.  Center tape over damaged area, and stitch according to original construction and table 2, WP 0012 00. 3. If damage to orifice edge reinforcement extends onto a gore section or sections and requires replacement of the section or sections, place canopy on repair table, smooth out damaged area, and pin section or sections to table.  Be sure that radial and diagonal seams are straight.  Cut orifice edge reinforcement close to radial seams or radial and diagonal seams that border the damaged area.   Cut a length of type III nylon tape long enough to extend 4-inches beyond each radial seam or each radial seam and diagonal seam involved, and sear ends of tape.  Baste the 4-inch ends of tape in place.  Replace gore sections or section using the procedures in WP 0038 00, GORE SECTION.   Use tape as a guide for trimming edge of new section or sections.  Turn under raw edge ½-inch, and stitch tape in place using the same sewing machine, thread, and stitch range as specified in 2. above. END OF WORK PACKAGE







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.