TM 10-1670-272-23&P 0031 00
Hand tack the opposite end of the pad to the harness webbing, in two places, with two-turns of
doubled and waxed tape, lacing and tying.
m. Tie the ends of the lacing with a surgeons knot and a locking knot.
4. Ejector snap pad. Replace as follows:
a. Cut the tacking and remove the damaged ejector snap pad.
b. Cut a piece of type I, 3/16-inch-thick felt, 6-inches-long and 4-inches-wide; round all the corners on
a ¼-inch radius.