TM 10-1670-272-23&P 0031 00
Roll the flare, using the proper punch. Remove the assembly from the holding tool and check to
ensure the lever rotates freely.
6. Canopy release cable loop repair. Repair as follows:
A maximum of six (6) strands may be broken and removed.
a. Using small needle nose pliers, unwind the broken wire strand off the cord, to the point where it
meets the swaging, by twisting and turning the wire strand until it breaks off.
b. Repeat this procedure with the other end of the wire strand where it meets the latch assembly.
c. Using a small paintbrush, mark the cable at a point next to the latch assembly with yellow paint.
Once a cable is marked as repaired, it will no longer be eligible for
further repairs and must be replaced.
END OF WORK PACKAGE