• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
DIRECT SUPPORT MAINTENANCE MC1-1B/MC1-1E TROOP BACK PARACHUTE ASSEMBLY   SEARING AND WAXING
REMARKING AND RESTENCILING - TM-10-1670-272-23P_252

TM-10-1670-272-23P Parachute Personnel Type: 35-Foot Diameter MC1-1B Troop Back Parachute Assembly NSN 1670-00-598-0751 Manual
Page Navigation
  207    208    209    210    211  212  213    214    215    216    217  
TM 10-1670-272-23&P                                                       0035 00 DIRECT SUPPORT MAINTENANCE MC1-1B/MC1-1E TROOP BACK PARACHUTE ASSEMBLY   MARKING AND RESTENCILLING 0035 00-1 THIS TASK COVERS:    Marking    Restencilling    Remarking and Restencilling INITIAL SETUP: Materials/Parts Brush, Stenciling (Item 4, WP 0057 00) Ink, Marking, Strata-Blue (Item 22, WP 0057 00) Marker, Felt Tip, Black (Item 25, WP 0057 00) Pen, Ballpoint (Item 30, WP 0057 00) Stencil Board, Oiled (Item 39, WP 0057 00) Personnel Required 92R(10) Parachute Rigger Equipment Condition Laid out on packing table or other suitable area. NOTE Stenciling should be used whenever possible.  A ballpoint pen or felt tip marker should be used only were stenciling is not possible, or when stenciling devices are not available.  Any type ballpoint pen using black or blue ink may be used for marking on labels only. Original stenciled data or marking that becomes faded, illegible, obliterated, or removed as a result of performing a repair procedure, will be remarked with a ballpoint pen, felt tip marker, or restenciled.   All marking or restencilling will be done on, or as near as possible to, the original location and should conform to the original lettering type and size. MARKING    Using marking devices, such as a ballpoint pen or felt tip marker, mark on, or as near as possible to, the original location and conform to the original lettering type and size. RESTENCILING Proceed as follows: 1.    Cut oiled stencil board to match the original lettering type and size of data to be restenciled. 2.    Place cut stencil board over, or as near as possible to, the original marking to be restenciled. 3.    Place an additional sheet of stencil board beneath the area to be restenciled to prevent the marking ink from penetrating to other areas. 4.    Hold the stencil board in place and, using the stenciling brush filled with parachute marking ink, restencil the original marking.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.