• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
DIRECT SUPPORT MAINTENANCE MC1-1B/MC1-1E TROOP BACK PARACHUTE ASSEMBLY   GORE SECTIONS CONT. - TM-10-1670-272-23P_259
DIRECT SUPPORT MAINTENANCE MC1-1B/MC1-1E TROOP BACK PARACHUTE ASSEMBLY GORE SECTIONS CONT. - TM-10-1670-272-23P_261

TM-10-1670-272-23P Parachute Personnel Type: 35-Foot Diameter MC1-1B Troop Back Parachute Assembly NSN 1670-00-598-0751 Manual
Page Navigation
  216    217    218    219    220  221  222    223    224    225    226  
TM 10-1670-272-23&P                                                         0038 00 0038 00-4 a.    Invert canopy and center damaged section on the worktable. b.    Smooth the area around the damaged section; ensure that the radial and diagonal seams are straight. Place pins through the radial and diagonal seams, as far above and below the damaged sections as necessary. c.    Remove the damaged section by cutting the fabric ½-inch from all seams, except at the lower lateral band, where the section can be cut out flush with the lateral band. d.    If the damage does not extend into the corner bounded by the radial seam and the lower lateral band, cut the fabric diagonally across the corner with the warp or fill, leaving the corner intact.   Leave enough fabric at the corner so that when the new section is installed it will not overlap the pocket band or V-tab.  Adapt the procedures in step 1., above, to complete the section replacement. e.    If the damage extends into the corner bounded by the radial seam and lower lateral band, cut and remove the stitching that holds the V-tab and pocket band (if present).  Adapt procedures in step 1., above, to replace the section.  Then sew the V-tab and pocket band in place. f. Fold back the raw edges of the trimmed seams ½-inch and baste to the seam with size A, nylon thread, or ticket No. 24/4 cotton thread.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.