• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
DIRECT SUPPORT MAINTENANCE MC1-1B/MC1-1E TROOP BACK PARACHUTE ASSEMBLY GORE SECTIONS CONT. - TM-10-1670-272-23P_262
DIRECT SUPPORT MAINTENANCE MC1-1B/MC1-1E TROOP BACK PARACHUTE ASSEMBLY   SUSPENSION LINE

TM-10-1670-272-23P Parachute Personnel Type: 35-Foot Diameter MC1-1B Troop Back Parachute Assembly NSN 1670-00-598-0751 Manual
Page Navigation
  219    220    221    222    223  224  225    226    227    228    229  
TM 10-1670-272-23&P                                                         0039 00 DIRECT SUPPORT MAINTENANCE MC1-1B/MC1-1E TROOP BACK PARACHUTE ASSEMBLY   RADIAL TAPE 0039 00-1/(2 Blank) THIS TASK COVERS: = Replace INITIAL SETUP: Tools: Needle, Tacking (Item 19, WP 0044 00) Sewing Machine, Zig-Zag (Table 1, WP 0012 00) Shears (Item 28, WP 0044 00) Materials/Parts Webbing, Nylon, Type I, 9/16-IN. (Item 67,   WP 0057 00) Thread, Nylon, Size E (Item 53/56, WP 0057 00) Personnel Required 92R(10) Parachute Rigger Equipment Condition Parachute canopy laid out on table. REPLACE   1.    Place canopy in proper layout on repair table or repair surface; apply partial tension to suspension lines. 2.    Trace damaged radial tape from the canopy skirt, through the radial seam channel, to the canopy apex. 3.    Cut the stitching that holds the vent line and the radial tape to the upper lateral band and radial seam; lay next to the end of the vent line. 4.    Cut the stitching that holds the suspension line and radial tape to the lower lateral band and the radial seam; lay it next to the end of the suspension line.  Do not remove the damaged radial tape at this time. 5.    Tack the end of the new radial tape to the end of the damaged radial tape at the upper lateral band. 6.    Grasp the end of the damaged radial tape, at the lower lateral band, and pull the old tape through the radial seam channel until the new tape appears at the lower lateral band.  Relieve the tension from the suspension lines. 7.    Cut the old tape from the new tape at the tacking.  Hand tack the ends of the new radial tape in place, at the upper and lower lateral bands, after taking appropriate measurement of the adjacent tape. 8.    Cut the ends of the new tape at the outside edges of the upper and lower lateral bands.  Reposition the ends of the vent line and suspension line; sew in place according to the original construction.   END OF WORK PACKAGE







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.