TM 10-1670-277-23&P 0014 00
UNIT MAINTENANCE
28-FOOT DIAMETER CARGO EXTRACTION PARACHUTE
MARKING AND RESTENCILLING
0014 00-1
THIS TASK COVERS:
Marking
Restencilling
Remarking and Restencilling
Tools
Brush, Stencilling (Item 3, WP 0056 00)
Knife (Item 5, WP 0056 00)
Machine, Stencil Cutting (Item 8, WP 0056 00)
Materials/Parts
Ink, Marking, Parachute, Strata-Blue (Item 10, WP 0065 00)
Marker, Felt Tip, Black (Item 13, WP 0065 00)
Pen, Ballpoint (Item 14, WP 0065 00)
Stencilboard, Oiled (Item 16, WP 0065 00)
Personnel Required
92R (10) Parachute Rigger
Equipment Condition
Laid out on packing table or other
suitable area.
NOTE
Stenciling should be used whenever possible. A ballpoint pen or felt tip
marker should be used only where stenciling is not possible, or when
stenciling devices are not available. Any type ballpoint pen using black
or blue ink may be used for marking on labels only. Original stenciled
data or marking that becomes faded, illegible, obliterated, or removed
as a result of performing a repair procedure will be remarked with a
ballpoint pen, felt tip marker, or restenciled. All marking or restenciling
will be done on, or as near as possible to, the original location and
should conform to the original lettering type and size.
MARKING
Using marking devices, such as ballpoint pen or felt tip marker, mark on, or as near as possible to, original
location and conform to original lettering type and size.
RESTENCILING
Proceed as follows:
1. Cut oiled stencilboard to original lettering type and size of data to be restenciled.
2. Place cut stencilboard over, or as near as possible to, original marking to be restenciled.
3. Place additional sheet of stencilboard beneath the area to be restenciled to prevent the marking ink from
penetrating to the areas.
4. Hold stencilboard in place and, using stenciling brush filled with parachute marking ink, restencil original
marking.
