TM 10-1670-280-23&P 0016 00
100-FOOT DIAMETER CARGO PARACHUTE
MARKING AND RESTENCILLING
THIS TASK COVERS:
Remarking and Restencilling
Brush, Stenciling (Item 4, WP 0050 00)
Knife (Item 7, WP 0050 00)
Machine, Stencil Cutting (Item 11, WP 0050 00)
Ink, Marking, Parachute, Strata-Blue (Item 17, WP 0059 00)
Marker, Felt Tip, Black (Item 20, WP 0059 00)
Pen, Ballpoint (Item 24, WP 0059 00)
Stencilboard, Oiled (Item 26, WP 0059 00)
92R (10) Parachute Rigger
Laid out on packing table or other
Stenciling should be used whenever possible. A ballpoint pen or felt tip
marker should be used only where stenciling is not possible, or when
stenciling devices are not available. Any type ballpoint pen using black
or blue ink may be used for marking on labels only. Original stenciled
data or marking that becomes faded, illegible, obliterated, or removed
as a result of performing a repair procedure will be remarked with a
ballpoint pen, felt tip marker, or restenciled. All marking or restenciling
will be done on, or as near as possible to, the original location and
should conform to the original lettering type and size.
Using marking devices, such as ballpoint pen or felt tip marker, mark on, or as near as possible to, original
location and conform to original lettering type and size.
Proceed as follows:
1. Cut oiled stencilboard to original lettering type and size of data to be restenciled.
2. Place cut stencilboard over, or as near as possible to, original marking to be restenciled.
3. Place additional sheet of stencilboard beneath the area to be restenciled to prevent the marking ink from
penetrating to the areas.
4. Hold stencilboard in place and, using stenciling brush filled with parachute marking ink, restencil original