• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 2-110.  Normal Gore Section Replacement Details.
Canopy Gore Section (cont)

TM-10-1670-281-23P Parachute Cargo Type: 64-Foot Diameter Model G-12D NSN 1670-00-893-2371 and Model G-12E NSN 1670-01-060-3705 Manual
Page Navigation
  148    149    150    151    152  153  154    155    156    157    158  
ARMY TM 10-1670-281-23&P AIR FORCE T.O.  13C5-32-2 NAVY NAVAIR 13-1-32 (2)  Normal gore section replacement.  Gore sections are normally replaced as follows: (a) Remove the damaged section by cutting the section material at a point 1/2 inch in from the inside edge of each adjacent seam or lateral band. (b) Cut the remaining fabric diagonally at each corner to allow the raw edges to be folded back. (c) Fold each raw edge back by 1/2 inch and pin and baste each folded edge to complete area preparation.  Basting will be performed according to procedures in paragraph 2-19a. 4839-110 Figure 2-111.  Modified Gore Section Replacement Details. (d)  Position  a  piece  of  serviceable  parachute  cloth,  equal  to  the  material  used  in  original  gore  section construction, over the prepared area. (e) Cut the cloth piece to a size that will cover the entire prepared area.  Allow as many selveged edges of the cloth piece to remain as possible.  Also allow at least 3 inches of extra fabric to remain on each raw edge. (f) Fold under each selveged edge of the cloth piece to a width equal to the width of adjacent seams and aline the cloth folded edges with the outside edges of adjacent seams or bands.  Secure the seams or bands with pushpins. 2-131







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.