• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Figure 1.  Panel Layout for Stowing 120 FT Six Loop Extraction Line
Figure 2.  Extraction Line Separated into Two Groups of Six Plies and   Wrapped with Cloth

TM-10-1670-286-20 Extraction Line Panel NSN 1670-01-183-2678 Manual
Page Navigation
  36    37    38    39    40  41  42    43    44    45    46  
TM 10-1670-286-20 EXTRACTION LINE PANEL                                                                                                                          0008 00 STOWING 120-FOOT SIX LOOP EXTRACTION LINE TO EXTRACTION LINE PANEL 0008 00-3         d.  Cut one 42-inch length of ½-inch tubular nylon webbing, fold in half and girth-hitch to 1st, stow loop, center           row at lower edge of bottom panel.         e.  Cut two 8 x 16-inch pieces of cotton muslin cloth and two 36-inch lengths of ¼-inch type I cotton webbing,           position at lower edge of bottom panel.         f.  Cut and lay aside 36 x 38-inch sheet of kraft paper for use as line separator.         g.  Place 120 foot, six-loop extraction line on upper end of pack table or suitable surface.         h.  Measure and mark point on extraction line 5-feet from one end (this will be load attaching end).         i.  Route marked end of extraction line from upper end of panel to lower end along center row of stow loops.     2.  Stow extraction line.         a.  Separate extraction lines plies into two groups of six each and wrap each group with piece of 8 x 16-inch           cotton muslin cloth at point immediately above 5-foot mark on extraction line (figure 2).         b.  Secure wrapped plies together at each end with two turns of single ¼-inch wide type I cotton webbing           tie with surgeon’s knot and locking knot. CAUTION The extraction line must be firmly secured to the panel to prevent slippage and damage   during deployment.         c.  Pass running ends of 42-inch length of ½-inch tubular nylon webbing extraction line, pass each running           end in opposite directions, down and under stow loop and back to top of extraction line.  Secure running           ends on top of extraction line with surgeon’s knot, locking knot, and overhand knot on running ends           (figure 3). NOTE Ensure  that  the  extraction  line  stows  are  evenly  distributed  and  do  not  extend beyond  the  left  and  right  edge  of  the panel.  Do not secure ties until S-folds are completed.         d.  Beginning at lower left corner of bottom panel, make first S-fold/stow of extraction line and secure with           stow ties previously installed (figure 4).







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.