MC-4 RAM AIR FREE-FALL PERSONNEL PARACHUTE SYSTEM
MARKING AND RESTENCILING
0017 00-1/(2 Blank)
THIS TASK COVERS:
Brush, Stenciling (Item 5, WP 0063 00)
Machine, Stencil Cutting (Item 26, WP 0063 00)
Ink, Marking, Parachute (Item 25/26, WP 0076 00)
Marker, Felt Tip, Permanent, Black (Item 28, WP 0076 00)
Pen, Ball Point (Item 29, WP 0076 00)
Stencil Board, Oiled (Item 31, WP 0076 00)
92R (10) Parachute Rigger
Lay out on packing table or other
Stenciling should be used whenever possible. A ballpoint pen or
permanent felt tip marker should be used only where stenciling is
not possible, or when stenciling devices are not available. Any type
bail point pen using black or blue ink may be used for marking on
Original stenciled data or marking that becomes faded, illegible,
obliterated, or are removed as a result of performing a repair
procedure will be remarked with a ballpoint pen, felt tip marker, or
re-stenciled. All marking or re-stenciling will be done on or as near
as possible to the original location and should conform to the
original lettering type and size.
Using marking devices such as ballpoint pen or permanent felt tip marker, mark on, or as near as
possible to, original location and conform to original lettering type and size.
Proceed as follows:
1. Cut oiled stencil board to original lettering type and size of data to be re-stenciled.
2. Place cut stencil board over, or as near as possible to, original marking to be re-stenciled.
3. Place additional sheet or stencilboard beneath area to be re-stenciled to prevent marking ink from
penetrating to other areas.
4. Hold stencilboard in place and, using stenciling brush filled with parachute marking ink, re-stencil
END OF WORK PACKAGE