• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
UNIT MAINTENANCE MC-4 RAM AIR FREE-FALL PERSONNEL PARACHUTE SYSTEM AAD JUNCTION PLATE CONT. - TM-10-1670-287-23P_318
UNIT MAINTENANCE MC-4 RAM AIR FREE-FALL PERSONNEL PARACHUTE SYSTEM AR2 RIPCORD RELEASE POCKET (PADDED) - TM-10-1670-287-23P_321

TM-10-1670-287-23P MC-4 RAM Air Free-Fall Personnel Parachute System NSN 1670-01-306-2100 Manual
Page Navigation
  272    273    274    275    276  277  278    279    280    281    282  
TM 10-1670-287-23&P 0045 00 0045 00-3/(4 Blank) c.    Using a punch and rawhide mallet or other non-steel impact device, spread grommet barrel by hammering until barrel collar is rolled down smooth on washer.  If grommet barrel splits during hammering, remove and replace installed grommet with a serviceable item from stock.  Repeat the procedure in steps b. and c., above. 7.    Tack AAD Junction plate to side flap using tape, lacing and tying, single.  Starting on inside of side flap, pass lacing tape up through one of the large round holes on wide end of AAD Junction plate.   Continue to tack through holes on that side of AAD Junction plate until reaching the stitching securing the stiffener (6th small hole), then return stitching through holes back to starting point.  Secure with surgeon’s knot and locking knot.  Trim free ends ¾-inch from knot. 8.    Repeat step 7., on other side of AAD Junction plate. 9.    Replace grommet IAW step 6., above. END OF WORK PACKAGE Tacking Grommet







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.