• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
DIRECT SUPPORT MAINTENANCE MC-4 RAM AIR FREE-FALL PERSONNEL PARACHUTE SYSTEM SEARING AND WAXING
DIRECT SUPPORT MAINTENANCE MC-4 RAM AIR FREE-FALL PERSONNEL PARACHUTE SYSTEM SUSPENSION LINES (LINES 4A/B AND 5 A/B ONLY)

TM-10-1670-287-23P MC-4 RAM Air Free-Fall Personnel Parachute System NSN 1670-01-306-2100 Manual
Page Navigation
  306    307    308    309    310  311  312    313    314    315    316  
TM 10-1670-287-23&P 0052 00 DIRECT SUPPORT MAINTENANCE MC-4 RAM AIR FREE-FALL PERSONNEL PARACHUTE SYSTEM MARKING AND RESTENCILING 0052 00-1/(2 Blank) THIS TASK COVERS: Marking Restenciling INITIAL SETUP: Tools Brush, Stenciling (Item 5, WP 0063 00) Machine, Stencil Cutting (Item 26, WP 0063 00) Materials/Parts Ink, Marking, Parachute (Item 25/26, WP 0076 00) Marker, Felt Tip, Permanent, Black (Item 28, WP 0076 00) Pen, Ball Point (Item 29, WP 0076 00) Stencil Board, Oiled (Item 31, WP 0076 00) Personnel Required 92R (10) Parachute Rigger Equipment Condition Lay out on packing table or other   Suitable area. NOTE Stenciling should be used whenever possible. A ballpoint pen or permanent felt tip marker should be used only where stenciling is not possible, or when stenciling devices are not available.  Any type bail point pen using black or blue ink may be used for marking on labels only. Original stenciled data or marking that becomes faded, illegible, obliterated, or are removed as a result of performing a repair procedure will be remarked with a ballpoint pen, felt tip marker, or re-stenciled. All marking or re-stenciling will be done on or as near as possible to the original location and should conform to the original lettering type and size. MARKING Using marking devices such as ballpoint pen or permanent felt tip marker, mark on, or as near as possible to, original location and conform to original lettering type and size. RESTENCILING Proceed as follows: 1.    Cut oiled stencil board to original lettering type and size of data to be restenciled. 2.    Place cut stencil board over, or as near as possible to, original marking to be restenciled. 3.    Place additional sheet or stencilboard beneath area to be re-stenciled to prevent marking ink from penetrating to other areas. 4.    Hold stencilboard in place and, using stenciling brush filled with parachute marking ink, restencil original marking. END OF WORK PACKAGE







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.