• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
CLEANING FABRIC ITEMS WITH A SOLUTION OF HAND DISHWASHING COMPOUND - TM-10-1670-292-23P_60
DRYING FABRIC ITEMS - TM-10-1670-292-23P_62

TM-10-1670-292-23P Parachutes Personnel Type: 35-Foot Diameter MC1-1C Troop Back Parachute Assembly NSN 1670-01-262-2359 Manual
Page Navigation
  33    34    35    36    37  38  39    40    41    42    43  
TM 10-1670-292-23&P                                                       0008 00 0008 00-3 RINSING PARACHUTE ASSEMBLY IMMERSED IN FRESH-WATER Any parachute, or its components, that has been immersed in a fresh water lake, river, or stream will not require rinsing unless it has been ascertained that the water is dirty, oily, or otherwise contaminated.   Procedures for handling a fresh water immersed parachute are as follows: 1.    Contaminated fresh water.  If the parachute, or its components, has been immersed in contaminated fresh-water, rinse and dry (see RINSING PARACHUTE ASSEMBLY IMMERSED IN FRESH WATER, above), and, if applicable, repair. 2.    Uncontaminated fresh-water.  If the parachute, or its components, has been immersed in uncontaminated fresh-water, it will be cleaned and dried as outlined in CLEANING FABRIC ITEMS WITH A SOLUTION OF HAND DISHWASHING COMPOUND, DRYING FABRIC ITEMS, and CLEANING METAL ITEMS, in the detailed paragraphs above and below.  Minor discoloration of fabric items, resulting from immersion in uncontaminated fresh-water, may occur. NOTE Fabric items will not be dried in direct sunlight or by laying an item on the ground. DRYING FABRIC ITEMS Dry fabric items as follows: 1.    Suspend or elevate the item in a well-ventilated room or in a heated drying room. 2.    Using electric circulating fans may reduce drying time. 3.    When heat is used, the heat temperature shall not exceed 160 degrees Fahrenheit (71 degrees Celsius).  The preferred temperature is 140 degrees Fahrenheit (60 degrees Celsius). CLEANING METAL ITEMS    Clean metal items as follows: CAUTION Use care not to damage the adjacent fabric materials. 1.    Remove burrs, rough spots, rust, or corrosion from metal items by filing with a metal file, or by buffing and polishing with abrasive cloth. 2.    Remove all oils and filings by brushing and cleansing with dishwashing compound.  Allow to dry.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.