• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
TYING THE STATIC LINE TO THE BRIDLE LOOP OF THE CANOPY CONT. - TM-10-1670-293-23P_101
STOWING THE CANOPY CONT.

TM-10-1670-293-23P Parachute Personnel Type: 35-Foot Diameter T-10C Troop Back Parachute Assembly NSN 1670-01-248-9502 Manual
Page Navigation
  71    72    73    74    75  76  77    78    79    80    81  
TM 10-1670-293-23&P    0011 00 Change 1 0011 00-30 NOTE A packing paddle may be used to aid in tying the breakcord tie.   Remove the packing paddle after completing the tie. 5.    Secure the ends of the cotton webbing, over the buffer loop, with a surgeon’s knot and locking knot.   Allow approximately a 3-inch loop between the static line buffer loop and the bridle loop.  Trim the ends to approximately 2-inches. 6.    Rigger check number 3. STOWING THE CANOPY Proceed to stow the canopy as follows: 1.    Release tension and unhook the bridle loop from the apex hook.  Hold the deployment bag open with the right hand and grasp the canopy near the apex.  Place the apex of the canopy into the upper right corner of the deployment bag. 2.    Grasp the canopy with the left hand, approximately the width of the deployment bag, and place the second stow in the upper left corner. 3.    Continue stowing the canopy, in alternating sides of the deployment bag, until the lower lateral band and the anti-inversion net are reached.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.