• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
UNIT MAINTENANCE T-10C/T-10D TROOP BACK PARACHUTE ASSEMBLY PACKING PROCEDURES CONT. - TM-10-1670-293-23P_75
UNIT MAINTENANCE T-10C/T-10D TROOP BACK PARACHUTE ASSEMBLY PACKING PROCEDURES CONT. - TM-10-1670-293-23P_77

TM-10-1670-293-23P Parachute Personnel Type: 35-Foot Diameter T-10C Troop Back Parachute Assembly NSN 1670-01-248-9502 Manual
Page Navigation
  45    46    47    48    49  50  51    52    53    54    55  
TM 10-1670-293-23&P    0011 00 Change 1 0011 00-4 c.     Pass the top of the snap hook through the static line loop.    d.    Continue passing the snap hook through the static line loop; pull the excess static line back through the opening in the base of the snap hook until the loop is past the snap hook opening.   e.    Slide the loop down to the bottom of the snap hook until the static line is fully seated in the indent on the side of the snap hook; form a taut girth-hitch.    f. Ensure there are no twists in the static line snap hook loop. NOTE Before forming the girth-hitch, the green ID marking thread on the USL and USL extension must be on top. 3.    Attaching the USL extension to the USL.   a.    Attach the USL snap hook to the USL extension as stated in paragraph 2, above.    b.    Pass the 3½-inch loop, on the USL, through the 2-inch buffer loop, on the USL extension.  







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.