• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Ring Strap Assembly cont. - TM-10-1670-299-20P_178
RELEASE ASSEMBLY CONT. - TM-10-1670-299-20P_180

TM-10-1670-299-20P Ancillary Equipment fro Personnel Troop Parachute System Manual
Page Navigation
  164    165    166    167    168  169  170    171    172    173    174  
TM 10-1670-299-20&P TO 14D1-2-470-2 NAVAIR 13-1-41 2-24.  RELEASE ASSEMBLY This task covers: a. Inspect c. Replace b. Repair INITIAL SETUP Tools: Knife, Item 1, Section III, Appendix B Shears, Item 2, Section III, Appendix B Materials/Parts: Tape, nylon, Item 34, Appendix D Thread, nylon, size E, Item 36, Appendix D Thread, nylon, size FF, Item 37, Appendix D Cord, fibrous nylon, Item 9, Appendix D General Safety Requirements: Read, understand and follow all warnings, cautions and notes. Equipment Condition: The Release Assembly should be clean and dry.  Place the assembly on a work table. INSPECT Perform a before and after repair rigger/technical inspection of the Release Assembly as outlined in paragraph 2-14. REPAIR The webbing on the release assembly may be restitched or darned. Splicing is not authorized.  Restitch loose, broken, or defective stitching according to original construction details using size FF thread, 7 to 9 stitches per inch and a type MD sewing machine. Darn using size E thread and a type DN machine. 2-148







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.