TEST CHAMBER ASSEMBLY, MODEL 452
OPERATION UNDER USUAL CONDITIONS
DECALS AND INSTRUCTION PLATES
CONNECTIONS SCHEMATIC decal provides identification of electrical connections (for location,
refer to Page 2, WP 0007 00).
PREPARATION FOR MOVEMENT
If necessary, open altitude chamber lid and remove AR2.
Prepare AR2 for storage or shipment (refer to WP 0023 00).
Disconnect control assembly power cable from 110 VAC outlet. Coil power cable behind control
The test chamber and carrying case weighs 70 lbs. The test chamber weighs 50
lbs. Use two persons or lifting device when moving or lifting to prevent injury to
Install test chamber in carrying case. Close and lock carrying case lid.
0009 00-13/14 Blank