TM 10-1670-272-23&P 0011 00
0011 00-25
21. Raise the top radial tape (no. 30) and check for a clear channel. Also check to ensure that the left
control line is with the left suspension line group, and the right control line is with the right suspension
line group.
NOTE
If material is in the channel, repeat the fine dressing procedure.
22. Rigger check number 2.
LONGFOLDING THE CANOPY
After flat folding, the canopy is ready for long folding. Proceed as follows:
1. The anti-inversion net and the lower lateral band of the canopy will be folded 180 degrees, with the
right group folded first, so that the lower edges are parallel to each other and are slightly extended
(approximately 2-inches) over the two groups of suspension lines.
