ARMY TM 10-1670-276-23&P
AIR FORCE T.O. 13C5-29-2
NAVY NAVAIR 13-1-29
h. Replace. To remove an unserviceable item and install a serviceable counterpart in Its place. "Replace" is
authorized by the MAC and is shown as the 3d position code of the SMR code.
i. Repair. The application of maintenance services, including fault location/troubleshooting, removal/installation, and
disassembly/assembly procedures, and maintenance actions to identify trouble and restore serviceability to an item by
correcting specific damage, fault, malfunction, or failure in a part, subassembly, module (component or assembly), end
item, or system.
j. Overhaul. That maintenance effort (service/action) prescribed to restore an item to a completely serviceable.
operational condition as required by maintenance standards in appropriate technical publications (i.e., DMWR).
Overhaul is normally the highest degree of maintenance performed by the Army Overhaul does not normally return an
item to like new condition.
k. Rebuild. Consists of those services/actions necessary for the restoration of unserviceable equipment to like new
condition in accordance with original manufacturing standards. Rebuild is the highest degree of materiel maintenance
applied to Army equipment. The rebuild operation includes the act of returning to zero those age measurements
(hours/miles, etc. ) considered in classifying Army equipment/components.
B-3. Explanation of Columns in the MAC, Section II.
a. Column 1. Group Number. Column 1 lists functional group code numbers the purpose of which is to identify
maintenance significant components, assemblies, subassemblies, and modules with the next higher assembly End item
group shall be "00".
b. Column 2. Component/Assembly. Column 2 contains the names of components, assemblies, subassemblies, and
modules for which maintenance is authorized.
c. Column 3. Maintenance Function. Column 3 lists the functions to be performed on the item listed in Column 2 (For
detailed explanation of these functions, see paragraph B-2).
d. Column 4. Maintenance Level. Column 4 specifies, by the listing of work lime figure in the appropriate
subcolumn(s), the level of maintenance authorized to perform the function listed in Column 3. This figure represents the
active time required to perform the function listed in indicated level of maintenance If the number or complexity of the
tasks within the listed maintenance function vary at different maintenance levels, appropriate work time figures will be
shown, for each level. The work time figure represents the average time required to restore an item (assembly,
subassembly, component, module and item, or system) to a serviceable condition under typical field operating
conditions.
This
time
includes
preparation
time
(including
any
necessary
disassembly/assembly
time),
troubleshooting/fault location time, and quality assurance/quality control time in addition to the time required to perform
the specific tasks identified for the maintenance functions authorized in the maintenance allocation chart. The symbol
designations for the various maintenance levels are as follows:
C
-
Operator or crew
O
-
Unit Maintenance
F
-
intermediate Direct Support Maintenance
H
-
intermediate General Support Maintenance
D
-
Depot Maintenance
e. Column 5. Tools and Equipment. Column 5 specifies by code, those common tools sets (not individual tools) and
special tools, TMDE, and support equipment required to perform the designated function.
B-2
