TM 10-1670-277-23&P 0035 00
0035 00-2
REPLACE
1. Remove original grommet as follows:
a. Using a suitable type tool, lift edge of original washer at one point.
b. Grip lifted washer edge with diagonal cutters and roll washer edge back to lift washer from original
grommet. Remove original grommet from material.
2. Grommet installation by hand-held method.
a. Insert barrel of replacement grommet through accommodating hole in material and ensure grommet
flange is located on same side of material as original grommet.
b. Position grommet on die with barrel facing up and place the washer over grommet barrel.
NOTE
When installing a flat grommet by the hand-held method, ensure the
grommet barrel and washer are aligned to preclude off-center setting of
the grommet.
