ARMY TM 10-1670-278-23&P
AIR FORCE T.O. 13C5-26-2
NAVY NAVAIR 13-1-27
2-19. Searing and Waxing.
This task covers:
a. Searing
b. Waxing
Tools:
Personnel Required:
Knife, Hot Metal, Item 2, Appendix B
43E(10) Parachute Rigger
Pot, Melting, Electric, Item 9, Appendix B
Equipment Condition:
Materials/Parts:
Unpacked
Beeswax, Item 2, Appendix D
Wax, Paraffin, Item 33, Appendix D
CAUTION
Cotton tape, webbing, or cord will not be seared.
NOTE
Fabric materials such as cord, tape, and webbing that are cut for use in the
maintenance of back parachutes will normally be heat-seared or dipped in a
melted wax mixture, as applicable, to prevent the material from fraying or
unraveling. However, in some instances the preparation of the material may not
be necessary and will be specified accordingly.
a. Searing. The cut ends of nylon tape, webbing, and cord lengths may be prepared by heatsearing which is
performed by pressing the raw end of the material against a hot metal surface (knife) until the nylon has melted
sufficiently. Avoid forming a sharp edge or lumped effect on the melted end.
b. Waxing. The fraying or unraveling of cotton or nylon tape, webbing, and cord length ends may be prevented by
dipping 1/2-inch of the raw end of the material into a thoroughly melted mixture of half beeswax and half paraffin in an
electric melting pot. The wax temperature should be substantial enough to insure the wax completely penetrates the
material rather than just coating the exterior fabric.
2-55
