TM 10-1670-280-23&P 0013 00
0013 00-25
c. Pass the canopy attaching loop through the deployment bag from the bag open end and through the
vent line hole located in the bag closed end. Allow 12-inches of the attaching loop and serviced vent
lines to extend from the vent line hole.
d. Secure the canopy attaching loop to the breakcord attaching loop of the deployment bag bridle
assembly with an 18-inch length of type III nylon cord.
e. Pass one end of the cord length through the canopy attaching loop and through the breakcord
attaching loop of the deployment bag bridle assembly.
f.
Secure the cord ends with a surgeon’s knot and a locking knot.
g. Make and overhand knot in each running end.
h. Trim each tie end at a point 2-inches from the surgeon’s knot and locking knot.
i.
Rigger check number 4 (1st portion).
