TM 10-1670-280-23&P 0044 00
0044 00-9
h.
Cut old line from new line at the whip stitching to include waxed end.
i.
Make certain that approximately 10-inches of new line still extends beyond link assembly, and mark
new line at point even with inside edge of link.
j.
Hold adjacent line and new line tightly together at link, and trace both lines from link to canopy skirt
under equal tension.
k.
Mark new line where lines reach lower edge of lower lateral band (refer to illustration below).
l.
Check correctness of marking by again applying equal tension to both sides.
m. Hold adjacent line and new line together at lower lateral band, grasp both lines at upper lateral band,
and apply equal tension to both.
n.
Mark line at upper edge of upper lateral band.
o.
Check correctness of marking.
p.
Hold adjacent line and new line tightly together at upper lateral band and trace both lines to opposite
side of vent under equal tension.
q.
Mark new line where lines reach upper edge of upper lateral band.
r.
Check correctness of marking.
s.
Hold adjacent line and new line tightly together at upper lateral band, grasp both lines at lower lateral
band, and apply equal tension to both lines.
