TM 10-1670-286-20
EXTRACTION LINE PANEL 0009 00
STOWING 140-FOOT THREE LOOP EXTRACTION LINE TO EXTRACTION LINE PANEL
0009 00-1
THIS SECTION COVERS:
Stowing
INITIAL SETUP
Tools
Knife – NSN 5110-00-162-2205
Materials/Parts
(2) Extraction Line Panels – NSN 1670-01-183-2678
Extraction Line, 140-FT, Three Loop – NSN 1670-01-107-7651
Band, Rubber, Retainer – Item 1, Appendix C
Cloth, Muslin-Cotton – Item 4, Appendix C
Webbing, Cotton, Type I – Item 16, Appendix C
Webbing, Nylon, Tubular – Item 17, Appendix C
Personnel Required
92R (10) Parachute Rigger
Equipment Condition
All equipment shall be serviceable and ready for use.
References
WP 0002 00-2
Extraction Line Panel
WP 0003 00
Service and Repair
TM 10-1670-296-20&P
Extraction Line
STOWING
NOTE
Throughout this task the terms Right, Left, Upper, Lower,
Clockwise, Counterclockwise, Top and Bottom indicate directions,
as viewed by the Rigger, standing at the Tension Board end of a
parachute pack table looking toward the apex end.
When “two Extraction Line Panels” are laced together, the item
then takes the noun nomenclature of Extraction Line Bag.
Load attaching end of the Extraction Line Bag is laced closed with
½-inch tubular nylon webbing.
1. Layout
a. Position two Extraction Line Panel on pack table or suitable surface with stow loops facing up and
running lengthwise (figure 1).
