TM 10-1670-292-23&P 0014 00
UNIT MAINTENANCE
MC1-1C/MC1-1D TROOP BACK PARACHUTE ASSEMBLY
MARKING AND RESTENCILLING
0014 00-1
THIS TASK COVERS:
=
Marking
=
Restencilling
=
Remarking and Restencilling
INITIAL SETUP:
Materials/Parts
Brush, Stenciling (Item 4, WP 0055 00)
Ink, Marking (Item 22, WP 0055 00)
Marker, Felt Tip, Black (Item 25, WP 0055 00)
Pen, Ball Point (Item 28, WP 0055 00)
Stencil Board, Oiled (Item 35, WP 0055 00)
Personnel Required
92R(10) Parachute Rigger
Equipment Condition
Laid out on packing table or other suitable area.
NOTE
Stenciling should be used whenever possible. A ballpoint pen or felt
tip marker should be used only were stenciling is not possible, or
when stenciling devices are not available. Any type ballpoint pen
using black or blue ink may be used for marking on labels only.
Original stenciled data or marking that becomes faded, illegible,
obliterated, or removed as a result of performing a repair procedure,
will be remarked with a ballpoint pen, felt tip marker, or restenciled.
All marking or restencilling will be done on, or as near as possible to,
the original location and should conform to the original lettering type
and size.
MARKING
Using marking devices, such as a ballpoint pen or felt tip marker, mark on, or as near as possible to, the
original location and conform to the original lettering type and size.
RESTENCILING
Proceed as follows:
1. Cut oiled stencil board to match the original lettering type and size of data to be restenciled.
2. Place cut stencil board over, or as near as possible to, the original marking to be restenciled.
3. Place an additional sheet of stencil board beneath the area to be restenciled to prevent the marking
ink from penetrating to other areas.
4. Hold the stencil board in place and, using the stenciling brush filled with parachute marking ink,
restencil the original marking.
