TM 10-1670-292-23&P 0031 00
0031 00-16
d. Pass the 16¼-inch length of webbing around the center bar of a serviceable adapter; align the
webbing ends. This length of material shall constitute the adjuster panel webbing.
e. Insert the 5-inch webbing length under the 16¼-inch webbing length, and pass the webbing length
around the adapter center bar to form a buffer. Extend the bottom end of the buffer webbing ¼-
inch beyond the top end.
f.
Hand-tack the buffer tightly to the adjuster panel webbing with two-turns of doubled tape, lacing
and tying. Secure the tacking thread ends, on the bottom side of the adjuster panel webbing, with
a square knot. Trim the tacking thread ends to ¼-inch.
