TM 10-1670-293-23&P
0033 00
DIRECT SUPPORT MAINTENANCE
T-10C/T-10D TROOP BACK PARACHUTE ASSEMBLY
GORE SECTIONS
0033 00-1
THIS TASK COVERS:
Replace
INITIAL SETUP:
Tools
Knife (Item 14, WP 0039 00)
Needle, Basting (Item 19, WP 0039 00)
Sewing Machine, Light Duty (Table 1, WP 0012 00)
Sewing Machine, Medium Duty (Table 1, WP 0012 00)
Shears (Item 29, WP 0039 00)
Materials/Parts
Brush, Stenciling (Item 4, WP 0053 00)
Cloth, Parachute Mending (Item 10, WP 0053 00)
Cloth, Parachute, Nylon, 1.1-oz. (Item 11, WP 0053 00)
Thread, Cotton (Item 43, WP 0053 00)
Thread, Nylon (Item 48/45, WP 0053 00)
Thread, Nylon (Item 47/44, WP 0053 00)
Stencil Board, Oiled (Item 32, WP 0053 00)
Pushpins
Personnel Required
92R(10) Parachute Rigger
Equipment Condition
Parachute canopy laid out on table.
References
Group No. 01, MAC (WP 0042 00)
REPLACE
When replacing gore sections, use 1.1-ounce ripstop pattern, nylon cloth of same color as that being
replaced. If the same color cloth is not available, another color may be used. When replacing section 1 of
gore 1, restencil gore number and information data block on the replacement section. For other gores,
stencil gore numbers as necessary.
NOTE
Mending cloth will be used for patching only.
1. Section 3 or 4. Replace as follows (see figure on next page):
