• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
UNIT MAINTENANCE MC1-1B/MC1-1E TROOP BACK PARACHUTE ASSEMBLY PACKING PROCEDURES CONT. - TM-10-1670-272-23P_74
RIGGERS POSITION

TM-10-1670-272-23P Parachute Personnel Type: 35-Foot Diameter MC1-1B Troop Back Parachute Assembly NSN 1670-00-598-0751 Manual
Page Navigation
  46    47    48    49    50  51  52    53    54    55    56  
TM 10-1670-272-23&P                                                       0011 00 0011 00-5 c.    Pass the snap hook, of the 5-foot extension, through the 3½-inch loop, on the 15-foot static line.    d.    Continue passing the snap hook through the 3½-inch loop until a taut girth-hitch is made securing the 5-foot extension to the 15-foot static line (There will be a half-twist in the 3½-inch loop when forming the girth-hitch). 4.    Technical/rigger-type inspection.  Before each parachute is packed by air delivery, it must be given technical/rigger-type inspection by the packer, in accordance with WP 0009 00. 5.    Pack-in-process inspection.  A designated supervisory rigger, other than the packer, must perform a pack-in-process inspection at seven intervals during the packing procedure.  The inspection is performed to ensure that the parachute is packed according to authorized packing procedures (refer to WP 0009 00). ORIENTATION Throughout this manual, all directions (right, left, upper, lower, top, bottom, clockwise, and counterclockwise) are given from the rigger’s point of view, as the rigger stands at the tension plate end of the packing table, facing the apex-hook end of the table.







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.