• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
Grommet - TM-10-1670-279-23P_122
Figure 2-54. Grommet Installation by Hand-Held Method.

TM-10-1670-279-23P Parachute Cargo Type: 22-Foot Diameter Cargo Extraction Parachute NSN 1670-01-063-3716 and NSN 1670-00-687-5408 Manual
Page Navigation
  99    100    101    102    103  104  105    106    107    108    109  
ARMY TM 10-1670-279-23&P AIR FORCE T.O. 13C5-27-2 NAVY NAVAIR 13-1-28 Figure 2-53.  Fabricating Grommet Reinforcement. b. Replace. Proceed as follows: (1)   Remove original grommet as follows: (a)   Using a suitable type tool, lift edge of original washer at one point. (b)   Grip lifted washer edge with lineman pliers and roll washer edge back to lift washer from original grommet. Remove original grommet from material. (2)    Grommet installation by hand-held method (figure 2-54). (a)   Insert barrel of replacement grommet through accommodating hole in material and ensure grommet flange is located on same side of material as original grommet. (b)   Position grommet on die with barrel facing up and place the washer over grommet barrel. NOTE When installing a flat grommet by the hand-held method, ensure the grommet barrel and washer are alined to preclude off-center setting of the grommet. 2-95







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.