TM 10-1670-268-20&P 0004 00
0004 00-12
b. Cargo extraction system. The extraction bracket assembly and the outside and inside EFTA
brackets must be installed on the platform. The following minor components must be installed on
the platform, as illustrated below:
NOTE
The extraction bracket assembly must be installed so that the
moveable lug will fold upward when the platform is right side up.
The upper part of the extraction bracket is stenciled TOP.
(1)
Extraction bracket assembly. Attach an extraction bracket assembly (1) on the center of
the rear panel, using a punch to align the four bolt-holes. Using a 15/16-inch wrench, install
the four 5/8-inch x 3 57/64-inch hex head bolts (2) with four 5/8-inch flat washers (3) and the
four 5/8-inch nuts (4) also with four 5/8-inch flat washers. These bolts must be installed from
the bottom.
NOTE
See the appropriate Field Manual (FM) that applies to the load
being dropped to determine the exact location on the side rail to
attach the EFTA brackets. See the appropriate FM for attaching the
EFTA to the brackets.
