TM 10-1670-269-23&P 0016 00 0016 00-1 UNIT MAINTENANCE 24-FOOT DIAMETER TROOP CHEST RESERVE (T-10R) PARACHUTE AND THE MIRPS MARKING AND RESTENCILLING THIS TASK COVERS:Marking Restencilling INITIAL SETUP: Tools Brush, Stenciling (Item 4, WP 0044 00) Materials/Parts Ink, Marking (Item 16/17, WP 0057 00) Marker, Felt Tip, Black (Item 18, WP 0057 00) Pen, Ball Point (Item 19, WP 0057 00) Stencil Board, Oiled (Item 27, WP 0057 00) Equipment Condition Layout on packing table or other suitable area. Personnel Required 92R (10) Parachute Rigger NOTE Stenciling should be used whenever possible. A ballpoint pen or authorized felt tip marker should be used only where stenciling in not possible, or when stenciling devices are not available. Any type ballpoint pen using black or blue ink may be used for marking on labels only. Original stenciling data or marking that becomes faded, illegible, obliterated, or removed as a result of performing a repair procedurewill be remarked with a ballpoint pen, felt tip marker, or restenciled. All marking or restenciling will be done on, or as near as possible to, the original location and should conform to the original lettering type and size. MARKING Using marking devices such as ballpoint pen or authorized felt tip marker, mark on or as near as possible to original location and conform to original lettering type and size. RESTENCILING Proceed as follows: 1. Cut oiled stencil board to original lettering type and size of data to be restenciled. 2. Place cut stencil board over, or as near as possible to, original marking to be restenciled. 3. Place additional sheet of stencilboard beneath the area to be restenciled to prevent the marking ink from penetrating to other areas. 4. Hold stencil board in place and, using stenciling brush filled with parachute marking ink, restencil original marking.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
