TM 10-1670-269-23&P
0038 00
0038 00-3/(4 Blank)
b. Except for the procedure in paragraph 1., step b., above, complete the section replacement using
the applicable procedures outlined in this WP and the illustration below.
NOTE
When replacing a gore section using the modified replacement
method, it is not necessary to remove the V-tab from the radial
seam located alongside the damaged section.
3. Multiple Gore Section Replacement. If two or more adjustment sections require replacement, cut and
remove all affected sections, including the joining diagonal seams as prescribed in this WP, above.
Prepare the material for the replacement sections and joint the replacement sections together with ½-
inch wide lapped seams (refer to illustration below). Install the joined replacement sections using the
applicable procedures in this WP, above.
END OF WORK PACKAGE
