ARMY TM 10-1670-275-23&P
AIR FORCE TO 13C5-25-2
NAVY NAVAIR 13-1-26
4706-053
Figure 2-48. Gore Section 3, Replacement Details.
(f) On each side of replacement gore section material, make a 314-inch wide fold under and align folded
edge with outside edge of each of original gore section radial tapes. Temporarily secure each of
side fold unders with pushpins.
(g) At upper end of replacement gore section, make a doubled 3/4-inch wide fold under and align upper
edge of fold with upper edge of vent reinforcement tape (upper lateral band). Temporarily secure
fold under with pushpins.
(h) Baste edges of replacement gore section in accordance with paragraph 2-17a and remove pushpins.
(i) Using a light duty sewing machine and thread secure replacement gore section to original gore
section radial tapes, vertical tape and vent reinforcement tape (upper lateral band) with two rows of
stitching, using 7 to 11 stitches.
(j) Remove basting, re-invert canopy to outside, and remove original gore section material by cutting up
inside of each applicable radial tape, up both sides of vertical tape, and across lower edge of vent
reinforcement tape (upper lateral band).
2-71
