TM 10-1670-286-20
EXTRACTION LINE PANEL PROCEDURES FOR C-17 GLOBEMASTER III 0017 00
ATTACHING THE 28-FOOT EXTRACTION PARACHUTE TO THE 140-FOOT, THREE LOOP
EXTRACTION LINE AND EXTRACTION LINE BAG
0017 00-1
THIS SECTION COVERS:
Stowing
INITIAL SETUP
Tools
Knife - NSN 5110-00-162-2205
Wrench Comb, 1 7/16-Inch – NSN 5120-00-228-9519
Wrench Comb, 1 1/2-Inch – NSN 5120-00-277-8834
Materials Parts
Parachute, 28-Foot Dia. – NSN 1670-00-040-8135
Link, Connector, Parachute – NSN 1670-00-217-2421
Side Plates, 5½-Inch – NSN 1670-00-003-1954 Spacers, Large – NSN 5365-00-007-3414
Bolts – NSN 5305-00-435-8994
Nuts – NSN 5310-00-232-5165
Webbing, Nylon, Tubular - Item 16, Appendix C
Webbing, Cotton, Type I - Item 15, Appendix C
Tape, Pressure Sensitive, Adhesive, 2-Inch – Wide, Item 17, Appendix C
Personnel Required
92R (10) Parachute Rigger
Equipment Condition
All equipment shall be serviceable and ready for use.
References
WP 0002 00-4
Extraction Line Panel
WP 0003 00
Service and Repair
WP 0012 00
Figure Eight Tie
TM 10-1670-277-23&P
28-Ft Extraction Parachute
STOWING
NOTE
Throughout this task the terms Right, Left, Upper, Lower, Clockwise,
Counterclockwise, Top and Bottom indicate directions, as viewed by the
Rigger, standing at the Tension Board end of a parachute pack table
looking toward the apex end. When two Extraction Line Panels are laced
together, the item then takes the noun nomenclature of Extraction Line
Bag.
