TM 10-1670-286-20
EXTRACTION LINE PANEL 0006 00
STOWING 60-FOOT THREE LOOP EXTRACTION LINE TO EXTRACTION LINE PANEL
0006 00-1
THIS SECTION COVERS:
Stowing
INITIAL SETUP
Tools
Knife – NSN 5110-00-162-2205
Material/Parts
(2) Extraction Line Panel – NSN 1670-01-183-2678
Extraction Line, 60-FT Three Loop – NSN 1670-01-062-6313
Band, Rubber, Retainer – Item 1, Appendix C
Cloth, Muslin-Cotton – Item 4, Appendix C
Webbing, Cotton, Type I – Item 16, Appendix C
Webbing, Nylon, Tubular, ½-Inch – Item 17, Appendix C
Personnel Required
92R (10) Parachute Rigger
Equipment Condition
All Equipment shall be serviceable and ready for use.
References
WP 0002 00-2
Extraction Line Panel
WP 0003 00
Service and Repair
TM 10-1670-296-20&P
Extraction Line
STOWING
NOTE
Throughout this task the terms Right, Left, Upper, Lower, Clockwise,
Counterclockwise, Top and Bottom indicate the directions, as viewed by the
Rigger, standing at the Tension Board end of a parachute pack table looking
toward the apex end.
When “two Extraction Line Panels” are laced together, the item then takes the
noun nomenclature of Extraction Line bag.
Load attaching end of the Extraction Line Bag is laced closed with ½-inch
tubular nylon webbing.
1. Layout.
a. Position two Extraction Line Panels on pack table or suitable surface with stow loops facing up and
running lengthwise.
