TM 10-1670-287-23&P
0013 00
0013 00-11
9. Set deployment breaks by opening excess line keeper on each rear riser and then pulling down on
each toggle until each finger-trapped loop is through each control line guide ring.
10. Insert stiffened top of each control line toggle through 1-inch loop Safety tack top center of control
toggle to center of riser with one turn double of 24/4 cotton thread, encircling the control line. Tie off
each tacking with a surgeon’s knot and a locking knot. Trim ends to ¼-inch. Ensure each loop with a
stiffened end of toggle is seated firmly against ring on riser.
Control
Line
Loop
Ring
Excess Line
Keepers
Loop
Tacking
Control
Toggle
