TM 10-1670-287-23&P
0002 00
0002 00-11
8. Main Riser Assembly. The main risers are constructed of Type VII nylon webbing. Each riser is 36-
inches in length. The bottom end of the main risers incorporates two riser release rings, a grommet,
and a main canopy release-locking loop. A channel is sewn to the back of the rear risers for stowage
of the main canopy release cable. The back of the rear risers incorporates control line keepers used
to stow excess control line, control line toggle keepers for stowage of control line toggles and control
line guide rings.
9. Free Fall Secondary FF-2. The automatic ripcord release is designed to open the main parachute
compartment automatically. It consists of a release mechanism mounted in a metal case and is
designed to work mechanically on barometric pressure. The arming cable, power cable, and the
power cable housings are located on one side of the case. The 14-inch power cable is attached to
the container base plate and the power cable is attached to the ripcord-locking pin. Refer to TM 10-
1670-300-20&P for operational limitations, maintenance, and repair.
560
RESET INDICATOR
Toggle Keepers
Riser Release
Rings
Trim Tabs
Excess Control
Line Keepers
Control Line Guide
Rings
Reset Indicator
Flangible Cap
Barrel
Reset Key Access
Hole Plug
Rectangular Key
Knurled Locking Nut
Withdrawl Hook
Rubber Bumper
Power Cable
14-IN.
Arming Pin
Assembly
Millibar Dial
Knob
Millibar Window
