TM 10-1670-292-23&P 0031 00
0031 00-6
(2)
Installation of a snap fastener may be performed by three different methods. The most
common method is the hand-held method that requires the use of a leather or other non-
steel impact device; a holder to hold the appropriate sized chuck; and an anvil, which is
used to contain a compatible sized die.
(3)
A second method of installing a snap fastener assembly is by use of the hand-operated
press. The hand-operated press is a lever-type device that can accommodate an
appropriate sized chuck and die. When installed in the hand-operated press, the chuck and
die are individually secured in position by a threaded screw that is tightened using a suitable
sized key (Allen-type hexagon wrench) or a flat-tip (common-head) screwdriver, as
applicable. The third method of snap fastener installation is by use of the foot-operated
press which, except for the means of operation, functions similar to the hand-operated
press.
