TM 10-1670-299-20&P
TO 14D1-2-470-2
NAVAIR 13-1-41
2-22. PARACHUTIST'S WEAPONS AND INDIVIDUAL EQUIPMENT PACK AND HARNESS ASSEMBLY.
This task covers:
a.
Inspect
c.
Replace
b.
Repair
INITIAL SETUP
Tools:
Knife, Item 1, Section III, Appendix B
Shears, Item 2, Section III, Appendix B
Materials/Parts:
Cloth, duck, cotton, Item 5, Appendix D
Tape, cotton. Type I, Item 32, Appendix D
Thread, nylon, size 3, Item 35, Appendix D
Thread, nylon, size E, Item 36, Appendix D
Thread, nylon, size FF, Item 37, Appendix D
Felt, 1/4 inch, Item 12, Appendix D
Webbing, nylon, Type VIII, Item 45, Appendix D
Webbing, nylon, Type IV, Item 46, Appendix D
General Safety Requirements:
Read, understand and follow warnings, cautions and notes.
Equipment Condition:
Pack and Harness Assembly should be clean and dry. Place pack and harness assembly on worktable.
INSPECT
Perform a before and after repair rigger/technical inspection of the lowering line as outlined in paragraph 2-14.
REPAIR
The pack (1) cotton duck (2) and felt (3) fabrics may be restitched, darned, and patched. The felt lining may be
restitched and plugged. When making any of these repairs, remove stitching (4) from side and end of pack as necessary
to gain
2-103
