Section III. OPERATION UNDER USUAL CONDITIONS
2-5. Initial Programming. Checks, and Self Tests.
a.
T/C Programming. (See Figure 2-11.)
(1)
Set rotary switch (I) to PRGM. Auxiliary switches AUX I through
AUX 6 (2) become programming switches as indicated by the red
print on them.
(2)
Press AUX 4 (PRGM CLR) switch (3). Observe that the CHANNEL
display (4) displays 01 and the red CHAN LED (S) lights.
(3)
Press AUX 2 (PRGM SET) switch (6). Observe that the CHANNEL
display (4) displays 01, indicating that channel I has been selected,
and that the red CHAN LED (5) blinks.
(4)
Select the channel that the system is in- tended to operate by
pressing the down arrow (7) or up arrow (8) switches. Refer to table
2-2.
WARNING
The channel programmed into the T/C must match
the channel selected for the AGU it is intended to
operate. Unmatched channels will result in loss of
system control, possible injury to personnel, or
equipment damage could result.
2-32
