0023 00-1
PREPARATION FOR STORAGE OR SHIPMENT
0023 00
AUTOMATIC RIPCORD RELEASE, MODEL 451, PREPARATION FOR STORAGE OR
SHIPMENT USING MODEL 452 TEST CHAMBER ASSEMBLY
PREPARATION FOR STORAGE
WARNING
Do not transport or store AR2 without piston rod cap, storage cable or power
cable attached. External forces or impacts applied to the piston rod may cause
unit to malfunction. Any unit subjected to external forces or impact must be
tested and, if necessary, removed from service.
NOTE
Make sure the AR2 is cocked, and the JUMP/OFF switch is set to OFF.
1. Pass ball end of storage cable (3) through piston rod cap (5) and then engage recess of
piston rod. Attach piston rod cap (5) to spring housing (6) of AR2. Pull eye end of storage
cable (3) to verify correct engagement.
2. Open lid of altitude chamber (7) and if necessary, remove cocking support (9).
3. Move air cylinder rod (4) as far to the right as it will go, approximately 1 inch.
