0023 00-5
PREPARATION FOR STORAGE OR SHIPMENT
0023 00
TEST CHAMBER ASSEMBLY, MODEL 452, PREPARATION FOR STORAGE OR SHIPMENT
1. With AR2 removed from altitude chamber, verify that altitude inside altitude chamber is at
ground level.
2. Verify that cocking support is inside the altitude chamber.
3. Close altitude chamber lid.
4. Disconnect power cord from 120 VAC and coil power cord under altitude chamber.
WARNING
Mounting base with attached components weighs 50 lbs. Weight when mounting
base is installed in carrying case is 70 lbs. Use two persons or lifting device to
prevent injury to personnel
5. Open carrying case (2) and carefully lower the mounting base (29) (with attached
components) into the carrying case (2). Close and latch carrying case lid.
6. Verify that correct serial number and mfg date are shown on the carrying case identification
decal (WP 0009 00).
STORAGE
Store unit in carrying case in a clean, dry area.
SHIPMENT
Ship unit in carrying case.
ELECTRONIC TEST CHAMBER ASSEMBLY, MODEL 453, PREPARATION FOR STORAGE
OR SHIPMENT
1. With AR2 removed from altitude chamber, verify that altitude inside altitude chamber is at
ground level.
2. Verify that cocking support is inside the altitude chamber.
3. Close altitude chamber lid.
4. Switch test chamber ON/OFF switch to OFF.
5. Disconnect power cord from 110 VAC power source and coil power cord under altitude
chamber.
